
A gas heater that hasn't been serviced in years can still feel warm while it burns badly. Poor combustion wastes gas, soots up the unit and, at worst, produces carbon monoxide you can't see or smell. A regular service keeps it safe, efficient and reliable.
GRAEME MARTIN - Certifying Master Gas Fitter & Plumber
45+ years experience
Pilot keeps going out? Yellow flame? Soot above the heater?
Gas Heater Servicing, Repairs & Installation

GAS HEATER SERVICING
We clean the burner and pilot, check the ignition and flame-failure safety device, test gas pressure, inspect the flue and check for carbon monoxide spillage. You'll know exactly what we found.

GAS HEATER REPAIRS
Won't light, cuts out, clicks without igniting, or smells when it's running. We find the fault, explain it in plain English and give you the price for parts before we fit them.

GAS FIRE & FIREPLACE SERVICE
Built-in gas fires and fireplaces from most brands. We clean the burner and glass, check the flue and venting, and make sure the fire lights and shuts down safely.

GAS HEATER INSTALLATION
New flued heaters, gas fires and heater replacements, with the gas line run and the flue installed to the manufacturer's requirements. Every install is pressure-tested and certified.

Book it before winter
Signs Your Gas Heater Needs a Service

Most manufacturers recommend a gas heater service every one to two years. Book sooner if you notice any of these:
A yellow or orange flame instead of a crisp blue one.
Soot or dark marks on the wall, ceiling or glass above the heater.
A pilot light that keeps going out, or a heater that clicks but won't light.
A smell of gas, or a stale, stuffy smell when it's running.
Headaches or drowsiness in the room while the heater is on. Turn it off and open a window.
Our gasfitters cover St Johns, Meadowbank, Remuera, Mission Bay, St Heliers, Glendowie, Ellerslie, Parnell, Epsom, Howick and across Auckland.
What a service includes
1. Safety check. Gas pressure, connections and the flame-failure device.
2. Clean. Burner, pilot assembly, fan and filters.
3. Flue and air supply. Inspected for blockages and correct venting.
4. Carbon monoxide test. We check the heater isn't spilling combustion gases into the room.
You'll know what we found, and the price of any parts, before we fit them. Need other gas work done while we're there? See our Auckland gas fitting services.
What Does a Gas Heater Service Cost?
No call-out fee. Visits start from $150 + GST, which covers travel and the first hour. This is a minimum visit charge, not an hourly rate. If the job takes longer, our hourly rate applies in 15-minute blocks.
What to expect
A standard gas heater service usually takes about an hour: $150 + GST, travel included.
Parts such as thermocouples, igniters and filters are priced separately, and we'll tell you the cost before we fit them.
More than one heater? We service them in the same visit at the hourly rate, so there's only one first-hour charge.
After-hours rates are published on our pricing page.
Recent Auckland job: St Heliers
The owners’ gas heater was on its way out. We checked it over, explained what we found and talked through repair versus replacement, so they could decide with the full picture.
Related gas services: gas leak detection, gas certificates, LPG to natural gas conversion and gas hob & BBQ installation. Or see all our gas fitting services in Auckland.

Gas Heater Questions We Get Asked
Most manufacturers recommend a service every one to two years. Book one before winter, and sooner if the flame looks yellow, the pilot keeps going out or you notice soot.
There's no call-out fee. Visits start from $150 + GST, which covers travel and the first hour, and most heater services take about an hour. This is a minimum visit charge, not an hourly rate. If the job takes longer, our hourly rate applies in 15-minute blocks. Parts are priced before we fit them.
We check gas pressure and connections, clean the burner and pilot, test the ignition and flame-failure device, inspect the flue and air supply, and test for carbon monoxide spillage.
A yellow or orange flame usually means the gas isn't burning cleanly, often because of a dirty burner, a blocked air supply or incorrect gas pressure. It wastes gas and can produce carbon monoxide, so turn the heater off and book a service.
Common causes are a worn thermocouple, a dirty pilot assembly or a draught near the heater. It's a safety device doing its job, so don't keep relighting it. A gasfitter can usually find and fix the cause in one visit.
Yes, if it's poorly maintained, the flue is blocked or the room isn't ventilated. Headaches, dizziness or drowsiness while the heater is on are warning signs. Turn it off, open a window and get it checked.
Yes. We service and repair built-in gas fires and fireplaces from most brands, including cleaning the burner and glass and checking the flue.
Yes. We run the gas line, install the heater and flue to the manufacturer's requirements, pressure-test the installation and certify it.
Yes. Calls are taken 24/7 on 09 570 2052. After-hours rates are published on our pricing page.






