
A new gas hob should be the easy part of a kitchen upgrade. The connection needs the right pipe size, the right pressure and a proper leak test, and the work has to be certified. Get it right first time and you'll be cooking the same day.
GRAEME MARTIN - Certifying Master Gas Fitter & Plumber
45+ years experience
New kitchen? Swapping electric for gas? Want a gas point on the deck?
Gas Hob, Cooktop & BBQ Gas Installation

GAS HOB INSTALLATION
We connect your new gas hob or cooktop, check the burners light cleanly at the right pressure, leak-test every joint and certify the work. Like-for-like swaps are usually done in an hour or two.

ELECTRIC TO GAS COOKTOP
Switching from electric to gas? We run a new gas line to the kitchen, size it so the hob gets full pressure, and coordinate with your electrician if the cooktop needs power for ignition.

OUTDOOR BBQ GAS POINT
Plug your BBQ or outdoor heater straight into the house gas supply with a bayonet fitting on the deck or patio. No more bottle swaps halfway through a barbecue.

RENOVATIONS & NEW BUILDS
Kitchen renovations, new builds and appliance relocations. We plan the gas runs with your builder, install the pipework at the right stage and certify the finished installation.

Before you buy
What to Check Before Buying a Gas Hob

A few checks now save a second visit later:
Natural gas or LPG? Buy the version for your supply, or one that comes with a conversion kit.
Cut-out size. Measure the existing benchtop hole if you are swapping like for like.
Power for ignition. Most hobs need a power point nearby for the igniters.
Clearances. Rangehoods and nearby walls need the gaps set out in the installation manual.
Not sure? Send us the model number when you book and we'll check it fits your setup.
Our gasfitters cover St Johns, Meadowbank, Remuera, Mission Bay, St Heliers, Glendowie, Ellerslie, Parnell, Epsom, Howick and across Auckland.
How an installation works
1. Check. We confirm the gas supply, pipe size and pressure at the hob.
2. Connect. The hob is fitted and connected with the correct fittings for your gas type.
3. Test. Every joint is leak-tested and each burner is checked for a clean, steady flame.
4. Certify. You receive a gas certificate for your records and your insurer.
Need other gas work done at the same time? See our Auckland gas fitting services.
What Does Gas Hob Installation Cost?
No call-out fee. Visits start from $150 + GST, which covers travel and the first hour. This is a minimum visit charge, not an hourly rate. If the job takes longer, our hourly rate applies in 15-minute blocks.
What to expect
Customer-supplied gas hob installation (like for like): from $400 + GST.
Electric-to-gas changes and outdoor BBQ gas points are quoted once we know the length of the gas run.
Any extra parts are priced before we fit them, so there are no surprises.
After-hours rates are published on our pricing page.
Recent Auckland job: St Heliers
A new kitchen benchtop was going in. We disconnected the gas hob before the old bench came out, reconnected it once the new one was in, then tested and certified the connection.
Related gas services: gas leak detection, gas heater servicing, gas certificates and LPG to natural gas conversion. Or see all our gas fitting services in Auckland.

Gas Hob Questions We Get Asked
Installing a customer-supplied gas hob like for like starts from $400 + GST. Electric-to-gas changes and new gas runs are quoted once we've seen the job. There's no call-out fee.
Yes. Connecting a gas appliance is gasfitting, which in New Zealand must be done by a licensed gasfitter and certified. A DIY connection can't be certified.
A like-for-like swap is usually done in an hour or two. Running a new gas line to the kitchen takes longer, depending on access.
Yes, if there's a gas supply to the property. We run a new gas line to the kitchen, connect the hob and certify the work. If the benchtop cut-out needs changing, your builder or kitchen company handles that first.
Most do, for the electric ignition. Check there is a power point within reach of the hob before installation day.
Yes. We run a gas line to a bayonet fitting on your deck or patio, so you can plug in a BBQ or outdoor heater without swapping bottles. It is tested and certified like any other gas work.
Usually, yes, using the manufacturer's conversion kit. Tell us the model when you book and we'll confirm before we arrive.
Yes. Every hob installation and gas point we fit is leak-tested and certified, and you receive the certificate for your records and your insurer.
Yes. Calls are taken 24/7 on 09 570 2052. After-hours rates are published on our pricing page.






